For daily repair posts follow on Facebook: https://www.facebook.com/MobileLabUK To find out more services and repairs we offer please contact us on Facebook =) Mobile Lab Gadgets Repair and Micro Soldering Specialists Nottingham, United Kingdom Steps Followed To Perform Repair: 1. Remove old connector by adding low melt solder and heating with an air gun at about 200 degrees. 2. Add low melt solder to pads. 3. Use solder wick and flux to remove old solder from pads. 4. Add more flux and place new Dock Connector/Charging Port. 5. Make sure connector is aligned and add solder to each pad. 6. Check connector is in place correctly then clean the area with isopropyl alcohol.