Bushing the firing pin hole in a 1873 Winchester bolt

Tony Small
0
5096

I had pre-made the bush and here I am machining the bolt face to take the bush. It is pressed in with a rod, held in the tailstock and some Locktite is added for good measure. The bush is then faced to level with the outer bolt face.

Published by: Tony Small Published at: 12 years ago Category: چگونه
Gunsmithing dideo دیدئو bolt دیدئو dideo bush face bushing firing pin hole winchester premade machining bush it pressed rod held tailstock locktite good measurethe faced level outer