Buy Dideo Subscription
In this video, I am talking about creating a new project in proteus software, that is how to place components in the schematic capture and building the circuit step by step. I am creating an led flasher circuit using 555 ic in Astable multivibrator configuration. In that mode the 555 ic goes to the high state, after a duration, it comes to low state and again it goes to the high state, so the cycle continues. At the output of the 555 ic, I connected two LEDs in series with a resistor, when the output is negative above led turn on and the output is positive below led turn on. In this way, the circuit works. Next by rectifying the simulation errors in the circuit and finally run the simulation and get the output. Project file link:https://drive.google.com/file/d/1YMJUGLrFL-wvfserAsjxSpR2haYLI8XG/view?usp=sharing For more details Email:keptlab@gmail.com Thank you so much for watching this video.
